Another Installation Method:
If it is not possible to install the edge connector according to the basic steps due to space limitations or other reasons, you can connect it from the side as follows:
1. Follow the first, second, and third steps of the basic procedure.
2. Remove the connecting connector and temporarily fix the four bus ducts to ensure their spacing and installation dimensions equal.
3. Press the connecting connector into the side.
4. Check the status of the connection bit at this time, which should be no different after completing the fourth point of the basic steps.
5. Follow the basic steps from point five to continue the installation.

1) Insulation partition
2) Torque screw
3) Connecting cover plate
4) Connector
5) Terminal
6) Insulator
7) Waterproof adhesive
8) Cover plate
9) Heat sink